HVAC Glossary

Home / HVAC Blog / HVAC Glossary


Glossary of Heating and Air Conditioning Terms

AFUE
Annual Fuel Utilization Efficiency. Indicated as a percentage, your furnace’s AFUE tells you how much energy is being converted to heat. For example, an AFUE of 90 means that 90% of the fuel is being used to warm your home, while the other 10% escapes as exhaust with the combustion gases.

Advanced Reciprocating Compressor
Type of compressor that uses a more efficient process for compressing refrigerant for better cooling efficiency.

Air Handler
The portion of your air conditioner or heating system that forces air through your home’s ductwork.

BTU: British Thermal Unit
Used for both heating and cooling, BTU is a measure of the heat given off when fuel is combusted. Or for cooling, it’s a measure of heat extracted from your home. (One BTU is approximately equal to the heat given off by a wooden kitchen match.)

BTUH: British Thermal Units per Hour

A British Thermal Unit (BTU) is the unit of heat required to raise one pound of water by one degree Fahrenheit.

Beckett Burner
A burner assembly within your oil furnace, manufactured by Beckett to exact specifications of Carrier. This burner provides good combustion of heating oil.

CFM: Cubic Feet per Minute
A measurement of airflow that indicates how many cubic feet of air pass by a stationary point in one minute. The higher the number, the more air is being forced through the system.

Capacity
The ability of a heating or cooling system to heat or cool a given amount of space. For heating, this is usually expressed in BTUs. For cooling, it is usually given in tons.

Carbon Monoxide
A colorless, odorless, highly poisonous gas produced when carbon-based fuels, such as natural gas, burns without sufficient air nearby.

Comfort Heat Technology
Carrier’s exclusive Comfort Heat Technology® accurately predicts the need for heating while cutting temperature swings in half.

Comfort Heat Technology Pump System
Comfort Heat Technology® Pump System is Carrier’s exclusive heat pump system that provides significantly warmer supply air from the registers for enhanced occupant comfort.

Compressor
Part of a split-system heat pump or air conditioner’s outdoor unit that controls the pressure applied to the refrigerant, necessary for taking in heat to warm your home with a heat pump or getting rid of heat to keep your home cool.

Condenser
An HVAC condenser is another term used to describe either an air conditioner or heat pump

Condenser Coil
Part of the outdoor portion of a split-system air conditioner or heat pump. By converting refrigerant that is in a gas form back to a liquid, the coil sends heat carried by the refrigerant to the outside.

dB: Decibels
dB are a unit measuring the intensity of noise.

Damper
A type of “valve” used in duct work that opens or closes to control airflow. Used in zoning to control the amount of warm or cool air entering certain areas of your home.

Dehumidifier
A device that can be added to your heating and cooling system that works to draw excess moisture out of indoor air.

Downflow
A type of furnace that takes cool air from the and blows warm air to the bottom-commonly used where furnaces must be located in a second-floor closet or utility area.

Ductwork
Hollow pipes used to transfer air from the Air Handler to the air vents throughout your home. Ductwork is one of the most important components of a home heating and cooling system.

EER
Energy Efficiency Ratings (EER) measure the efficiency with which a product uses energy to function. It is calculated by dividing a product’s BTU output by its wattage.

ENERGY STAR
ENERGY STAR® is a government-backed program helping businesses and individuals protect the environment through superior energy efficiency. Products with the ENERGY STAR rating will be efficient and save cost on energy bills.

EAC: Electronic Air Cleaner
An electronic device that filters out large particles and contaminants in indoor air. It then electronically pulls out tiny particles that have been magnetized, such as viruses and bacteria, drawing them to a collector plate.

Energy Saver Switch
An energy-saver switch causes the air conditioner’s fan and compressor to cycle on and off together, reducing energy use.

Evaporator Coil
Part of a split-system air conditioner or heat pump located indoors. The evaporator coil cools and dehumidifies the air by converting liquid refrigerant into a gas (or vice-versa). A blower moter, typically in a furnace, then moves air over the coil to either heat or cool your home.

Fan Coil
An indoor component of an air conditioner or heat pump system, used in place of a furnace and evaporator coil, to provide change the refrigerant from a gas to a liquid (or vice-versa) and blow air over the coil to cool or heat your home.

HSPF
The Heating Seasonal Performance Factor is a measure of the heating efficiency of a heat pump. The higher the HSPF number, the more efficiently the heat pump heats your home. (The cooling efficiency of a heat pump is measured by its SEER.)

HVAC
Term used for Heating, Ventilation, and Air Conditioning.

Heat Exchanger
The part of a furnace that transfers heat to nearby air.

Heat Pump
A product that works just like an air conditioner in cooling mode; however, in heating mode, the refrigerant flow is reversed and heat is extrated from the outside air too heat your home.

Horizontal Flow
A type of furnace, installed on its “side”, that draws in air from one side, heats it and sends the warm air out the other side. Most often used for installations in attics or crawl spaces.

Humidifier
A piece of equipment that adds water vapor to heated air as it moves out of the furnace. This adds necessary moisture to protect your furnishings and reduce static electricity.

Hybrid Heat

Hybrid Heat systems deliver exceptional performance by using a heating source that provides the most energy-efficient comfort during moderate heating conditions.

IdealDefrost
IdealDefrost is Carrier’s proprietary defrost management innovation for maintaining the ideal defrost interval for a heat pump, enhancing comfort and efficiency.

IdealHumidity
IdealHumidity™ is Carrier’s proprietary humidity management innovation for maintaining the ideal comfort in a home.

Indoor Coil
See Evaporator Coil

Inverter
A variable speed compressor that slows down or speeds up to match the heating and cooling load of the space. This also ensures higher comfort.

Load Estimate
A series of studies performed to determine the heating or cooling requirements of your home. An energy load analysis uses information such as the square footage of your home, window or door areas, insulation quality and local climate to determine the heating and cooling capacity needed by your furnace, heat pump or air conditioner. When referring to heating, this is often known as a Heat Loss Analysis, since a home’s heating requirements are determined by the amount of heat lost through the roof, entry ways and walls.

Low Boy

Low Boy is a type of furnace configuration in which the furnace is lower in height and occupies more floor space.

MERV: Minimum Efficiency Reporting Value

The standard comparison of the efficiency of an air filter. The MERV scale ranges from 1 (least efficient) to 16 (most efficient), and measures a filter’s ability remove particles from 3 to 10 microns in size.

Matched System

A heating and cooling system comprised of products that have been certified to perform at promised comfort and efficiency levels when used together, and used according to design and engineering specifications.

Operating Cost
The day-to-day cost of running your home comfort equipment, based on energy use.

Outdoor Coil
See Condenser Coil.

Payback Analysis
Overall measure of the efficiency and value of your home comfort system. By combining your purchase price and ongoing operating costs, a payback analysis determines the number of years required before monthly energy savings offset the purchase price.

Puron Refrigerant
Puron® refrigerant is an environmentally sound refrigerant designed not to harm the earth’s ozone layer. Federal law requires that all manufacturers phase out ozone depleting refrigerants in the next few years. Puron refrigerant is approved by the US Environmental Protection Agency as a replacement from Freon 22*.

R-22 Refrigerant
R-22 is a single component HCFC refrigerant with low ozone depletion potential. It has long been used in a variety of air-conditioning and refrigeration applications in a variety of markets. Per U.S. EPA regulations, new R-22 cannot be used in new systems effective in 2010, although service quantities of the refrigerant may be produced until 2020.

Reciprocating Compressor
A type of compressor used in air conditioners that compresses refrigerant by using a type of “piston” action.

Reclaiming
Returning used refrigerant to the manufacturer for disposal or reuse.

Recycling
Removing, cleaning and reusing refrigerant.

Refrigerant Lines
Two copper lines that connect the Condenser (Outdoor) Coil to the Evaporator (Indoor) Coil.

Riello Burner
A burner assembly within your oil furnace, manufactured by Riello to exact specifications of Carrier. This burner provides a cleaner, higher quality combustion of heating oil to increase energy efficiency.

SEER
The Seasonal Energy Efficiency Ratio is a measure of the cooling efficiency of your air conditioner or heat pump. The higher the SEER number, the more efficient the system is at converting electricity into cooling power.

SEER2: Seasonal Energy Efficiency Ratio 2
SEER2 is an updated version of the SEER calculation that uses the new M1 blower testing procedure which went into effect January 2023. The Seasonal Energy Efficiency Ratio 2 is used to compare the energy efficiencies of different central air conditioners and heat pump systems. Like miles per gallon for a car, the higher the SEER2, the more efficient the system.

Scroll Compressor
A specially designed compressor that works in a circular motion vs. an up and down piston action.

Silencer System
Carrier Silencer System II ensures quiet operation inside and out. Our systems meet or exceed local and industry sound standards with quiet motor mounts, a compressor sound blanket, forward swept fan blades, a laminated sound elimination compressor mounting plate and a unique top with integrated silencer airflow baffle.

Single Package Product
One outdoor unit that contains both a heating and a cooling system.

SmartRecovery
Smart Recovery starts the system in advance to be sure that each zone reaches your selected temperature setting at the scheduled time.

Split System
Refers to an air conditioner or heat pump that has components in two locations. Usually, one part of the system is located inside (evaporator coil) and the other is located outside your home (condenser coil).

Thermidistat
The Thermidistat™ Control monitors temperatures both inside and outside, as well as indoor humidity and adjusts system operation to maintain the temperature and humidity levels set by the homeowner.

Thermostat (Controllers)
Thermostats are units that monitors and controls your HVAC system products.

Thermostatic Expansion Valve
A thermostatic expansion valve (TXV) is precision device used to meter the flow of liquid refrigerant entering the evaporator at a rate that matches the amount of refrigerant being boiled off in the evaporator.

Ton
A unit of measure for cooling capacity. One ton = 12,000 BTUs per hour.

Total Home Comfort System
The ultimate solution to providing you with consistent, customized home comfort, despite the ever-changing weather.

Two-Stage Compressor
Two-Stage Compressors are capable of two levels of operation, a low stage and a high stage. Properly sized equipment will operate 80% of the time in low stage, enhancing efficiency and comfort with lower humidity levels and quieter operation. It’s like getting two air conditioners or heat pumps in one system.

UL
UL is an objective, non-profit organization that tests and rates electrical products for public safety.

Upflow
A type of furnace that draws cool air from the bottom and blows the warmed air out the  into the duct work. This type of furnace is usually installed in a basement or an out-of-the-way closet.

UV Lamps
Ultraviolet (UV) lamps kill bacteria, mold, and mildew on your cooling coil in your HVAC system to help create a healthier indoor environment.

Variable Speed
Variable-speed technology that allows your system to operate quietly and efficiently at longer, lower speed cycles throughout the day – meaning your system and comfort stay consistent.

Ventilator
ventilator captures heating or cooling energy from stale indoor air and transfers it to fresh incoming air.

WeatherArmor™
WeatherArmor™ is a Carrier innovation that protects outdoor units from weather and increases durability.

WeatherShield™

WeatherShield™ is a special coating of the outdoor condensing unit coil to resist corrosion from salt air found mainly in coastal areas.

Zoning
A way to increase your home comfort and energy efficiency by controlling when and where heating and cooling occurs in a home. Programmable thermostats are used to control operating times of the equipment. Dampers are used to direct air flow to certain parts or “zones” of the home.

Search for the nearest dealer to you:

Once you find a dealer, ask for a free, no-obligation quote for upgrading or repairing your existing home heating and cooling system.

      Looking For An HVAC System?

      Answer these 3 questions and we'll match you up with the perfect HVAC System for your home!
      START HERE

      Need A HVAC Dealer Near You?

      We've done all the hard work for you! Search our database of certified HVAC Dealers in your area.
      FIND A DEALER

      Back to Top